Every buzz, click, and rumble you feel in a consumer device comes from one of three actuator technologies: the eccentric rotating mass (ERM) motor, the linear resonant actuator (LRA), or the piezoelectric actuator. Which one a product uses is not a matter of fashion but a deliberate engineering trade-off among vibration power, precision, response time, cost, and durability. Texas Instruments' actuator comparison guide quantifies the gap starkly: an ERM takes roughly 50 milliseconds to respond, an LRA about 30, and a piezo actuator just 0.5 milliseconds—while cost climbs in the same order, from a single dollar sign for ERM to four for high-layer-count piezo.
Eccentric Rotating Mass (ERM) Actuators: Simple Power
An ERM is the simplest of the three: a small DC motor with an off-center weight attached to its shaft. When the motor spins, the imbalance shakes the whole device. Because the sensation depends on how fast the motor revs up, the feedback is inherently sluggish—those ~50 ms response times TI measured—and the motor is, in TI's words, "very noisy" audibly as well as power-hungry, with the highest energy consumption of any actuator in its comparison.
What ERMs offer in exchange is raw vibration power and rock-bottom cost. Elitac Wearables, a firm that engineers haptic systems for wearable devices, describes ERM motors as its "go-to option" for applications where power, cost, and simplicity are the primary concerns. Boréas Technologies, a piezo driver maker whose comparison was authored by Marc-andré Morin, similarly characterizes ERMs as low-cost motors suited to simple alerts. That combination explains why ERMs have long anchored budget wearables and basic notification buzzes: when the job is just "get the user's attention," an ERM does it cheaply and durably, even if it cannot render anything subtle.





